Making sure your power tools are protected from any harsh elements that can damage them can take its toll sometimes. We cannot guarantee that our power tools will be free from these harsh elements if we keep them in a high humidity storage space like garages and basements Below are very simple things you can do lessen your time and make you do other stuffs than fussing over your tools.

To obtain additional sound advice along with material concerning woodworking plans see my different blogs here woodworking plans

Power tools are always covered with a protective coating called cosmoline and you can always see this on a newly purchased tools . Before using the tool this coating should be removed and this will place your tools unprotected. Often times we strip our power tools of cosmoline without thinking of the need for ongoing protection .

To keep away the moisture it is advisable that our power tools are covered with protective coating . Buying commercially used rust preventive stuffs can be the one of the easiest way to do it . Boeshield T-9 and the Empire Top Saver are the two most popular brands.These sprays should be applied all over the tool making sure that there is no excesses left and this should be done periodically .

The unfortunate reality of tool ownership is that despite every good intention, tools left unprotected will eventually develop rust. And not checking the tools for a long time will eventually lead to more damages.

This is the jointer that is not sprayed with any rust protection. You can already see the increase in sawdust that invites rust to settle. After only 2 years, this tool was in need of some care.

In the earlier days people still use a steel wool to remove rust but how about the dust that is settled where the wool can't reach . There are now newly created products that can do this job .

A product called Rust Free by Boeshield is a rust remover that quickly removes rust. This is great on large tools that can't be soaked on rust solutions . Just spray this all over the rusted areas, wait for a minute then wipe it clean. Using an abrasive tool such as steel wool will aid in removing any rust left.

After following the steps using Rust Free, the jointer is now free of rust and is ready to have the rust preventative applied. If you look closely you can see a small rust pit. These pits are the unavoidable consequence of the rust. A rust pit can never be repaired by a rust removal.

Most rust removal sprays contain some type of acid. These acids will dissolve rust very quickly and the metal very slowly. When using Rust Free or any other spray, be sure to wear safety goggles and gloves to avoid contact with eyes and skin.

Protecting your power tools from rust need not to be hard and time consuming, just follow the steps above and you will be able to keep them for a lifetime.