Protecting your power tools from rust can sometimes feel like a full time job. Garages and basements are notoriously hard on tools due to the fact that these high humidity environments provide the perfect conditions for developing rust. Here are a few tips to cut off your time in cleaning them .

To get additional superb advice along with other guidance regarding woodworking tips go look at my alternative websites at woodworking plans

Every time you purchase a power tool it is always covered with a waxy and think coating to prevent the rust from eating up your power tools and this is known as cosmoline. Once it is in your shop, this coating must be removed and your cast iron top is no longer protected. Often times we strip our power tools of cosmoline without thinking of the need for ongoing protection .

In order for us to protect the cast irons we need to coat them again to keep the moisture away . Commercially made rust preventive products can be the easiest way to do it. There are actually 2 brands that you can purchase they are the Empire Top Saver and Boeshield T-9.These sprays works the same way, by applying them all over the cast iron and removing excesses carefully . This may be repeated frequently to ensure complete protection .

No matter how safely we keep our tools if these are kept without any protection it will still be eaten by rust. And we left it alone for a long time it will definitely damage the whole of it.

This jointer was left unprotected. There is already an accumulation of sawdust all over it that can cause rust. After a couple of years this cast iron will need care.

An abrasive tool is what is usually used to clean these cast irons, however problem arises when the rust are in the areas impossible to be reached. Fortunately, there are products available that can make this job a lot easier and more effective.

There is this new product in the market called Boeshield it is a rust remover product that can handle the job instantly. If you have larger tools that are impossible for you to soak in rust solution this is the thing for you. To use Rust Free you need to spray it on the rusted areas, wait a minute, and then just wipe dry. If there's still rust remaining you can use abrasive tools to remove it.

After following the steps using Rust Free, the jointer is now free of rust and is ready to have the rust preventative applied. If you examine the jointer you will see rust pits that is caused by rusts that was there before cleaning. A rust pit can never be repaired by a rust removal.

These rust removal is made up of acids that instantly removes rust and can slowly affect metals so make sure that you are using protective covering when you are using these products.

These methods can definitely help you preserve your power tools for a long time .